Services
Aerial Lift TrainingForklift Operator Certification
Instructor Courses
Mobile Crane Operator Certification
Online Training
Crane Operator Training
Overhead Crane Training
Rigging and SignalPerson Training
All Purpose Crane Training offers crane operator training on-site or off-site. Providing National accredited crane operator certification meeting OSHA ANSI standards for crane operators to become certified.
1926.1401
1926.1402
1926.1403
1926.1404
1926.1405
1926.1406
1926.1407
1926.1408
1926.1409
1926.1410
1926.1411
1926.1412
1926.1413
1926.1414
1926.1415
1926.1416
1926.1417
1926.1418
1926.1419
1926.1420
1926.1421
1926.1422
1926.1423
1926.1424
1926.1425
1926.1426
1926.1427
1926.1428
1926.1429
1926.1430
1926.1431
1926.1432
1926.1433
1926.1434
1926.1435
1926.1436
1926.1437
1926.1438
1926.1439
1926.1440
1926.1441
1926.1442
- (a) Safety devices. The following safety devices are required on all equipment covered by this subpart, unless otherwise specified:
- (1) Crane level indicator
- (i) The equipment must have a crane level indicator that is either built into the equipment or is available on the equipment.
- (ii) If a built-in crane level indicator is not working properly, it must be tagged-out or removed. If a removable crane level indicator is not working properly, it must be removed.
- (iii) This requirement does not apply to portal cranes, derricks, floating cranes/derricks and land cranes/derricks on barges, pontoons, vessels or other means of flotation.
- (2) Boom stops, except for derricks and hydraulic booms.
- (3) Jib stops (if a jib is attached), except for derricks.
- (4) Equipment with foot pedal brakes must have locks.
- (5) Hydraulic outrigger jacks and hydraulic stabilizer jacks must have an integral holding device/check valve.
- (6) Equipment on rails must have rail clamps and rail stops, except for portal cranes.
- (7) Horn
- (i) The equipment must have a horn that is either built into the equipment or is on the equipment and immediately available to the operator.
- (ii) If a built-in horn is not working properly, it must be tagged-out or removed. If a removable horn is not working properly, it must be removed.
- (b) Proper operation required. Operations must not begin unless all of the devices listed in this section are in proper working order. If a device stops working properly during operations, the operator must safely stop operations. If any of the devices listed in this section are not in proper working order, the equipment must be taken out of service and operations must not resume until the device is again working property. See 1926.1417 (Operation). Alternative measures are not permitted to be used.
